firoz16's photostream

populated board.bottom

All rights reserved

Uploaded on Jun 25, 2007

0 comments

populated board.top

All rights reserved

Uploaded on Jun 25, 2007

0 comments

making mounting holes using my homemade hand drill machine. www.youtube.com/watch? v=vIA_VvWnc2M

All rights reserved

Uploaded on Jun 25, 2007

0 comments

board after developing using fecl2.

All rights reserved

Uploaded on Jun 25, 2007

0 comments

do some repair if required.

All rights reserved

Uploaded on Jun 25, 2007

0 comments

after 15min.look at the below soaked paper.u'll find traces.the paper shld be like this. if u do...

All rights reserved

Uploaded on Jun 25, 2007

0 comments

soaking stage-2

All rights reserved

Uploaded on Jun 25, 2007

0 comments

soaking...

All rights reserved

Uploaded on Jun 25, 2007

0 comments

ironing setup.

All rights reserved

Uploaded on Jun 25, 2007

0 comments

printout on clay coated paper

All rights reserved

Uploaded on Jun 25, 2007

0 comments

helmet transmitter fixed to my brand new bike... :-) All these pic are taken by my SIS. thanks to her.

All rights reserved

Uploaded on Jul 5, 2006

2 comments

close up!!!

All rights reserved

Uploaded on Jul 5, 2006

0 comments

finished helmet with transmitter

All rights reserved

Uploaded on Jul 5, 2006

0 comments

helmet from side.

All rights reserved

Uploaded on Jul 5, 2006

0 comments

when breaks applied. LED's are bright enough,(like in lst pic) but position needs to be adjusted.

All rights reserved

Uploaded on Jul 5, 2006

0 comments

me with helmet. when breaks not applied.

All rights reserved

Uploaded on Jul 5, 2006

0 comments

yup...its me. i know bad back ground.

All rights reserved

Uploaded on Jul 5, 2006

0 comments

final product.

All rights reserved

Uploaded on Jul 5, 2006

4 comments

first trial.

All rights reserved

Uploaded on Jul 5, 2006

0 comments