|
Bill Schuller's photostream |
|
Luka Flys the kite he built at Maker Faire in Zilker Park
Cutting hardboard panel
Another view of my panel saw. I just have to back my wife's vehicle out into the driveway to make...
All rights reserved
Uploaded on Aug 28, 2008
Cutting hardboard panel
This is my panel saw. Start with four 8 foot 2x4's that at least don't have any twists and...
All rights reserved
Uploaded on Aug 28, 2008
Cutting Mortises: Closeup
Shavings are much easier to clean up than dust. And working by hand is soooo much quieter than firing up the mortising jig.
All rights reserved
Uploaded on Aug 27, 2008
Cutting Mortises: The "bench"
Since my Shopsmith Mark V is down for the count until I can get some replacement parts, I decided to...
All rights reserved
Uploaded on Aug 27, 2008
Sheave rubbing on the motor plate on my Shopsmith Mark V
The lower sheave is rubbing against the motor mounting plate. I'm calling Shopsmith to ask how to...
All rights reserved
Uploaded on Aug 23, 2008
Broken vbelt adjustment collar on my Shopsmith Mark V
While troubleshooting my rubbing sheave problem, I discovered that the v-belt tension adjustment...
All rights reserved
Uploaded on Aug 23, 2008
Marking Gauge stock detail
In this model a brass threaded insert is used to support the thumb screw.
All rights reserved
Uploaded on Aug 23, 2008
Marking Gauge spur and stock face detail
Dual spurs, brass inlay on the stock. Great lighting through my workshop window. I don't know why...
All rights reserved
Uploaded on Aug 23, 2008
Marking Gauge ajustable brass stem detail
I busted out my nicer camera that can actually handle macro (sorry iPhone, your camera is only...
All rights reserved
Uploaded on Aug 23, 2008
The finished product and the pharoh it was created for
Here's the best shot I have of the finished product, a few months after the job was done....
All rights reserved
Uploaded on Aug 20, 2008
Taping up for the final part of painting Luka's bedroom
I'm using a Craftsman Laser Level I purchased after reading a DealMonger post.
All rights reserved
Uploaded on Aug 20, 2008
45 degree mortise on the ShopSmith
Preparing a really rough 45 degree mortise with my ShopSmith and the mortising attachment. I'm...
All rights reserved
Uploaded on Aug 20, 2008
Antique Tools
I inherited some tools from my grandfather and these are the ones looking at. The two marking gauges...
All rights reserved
Uploaded on Aug 20, 2008
Workshop
Christmas Party
Thanksgiving 2007 (Tagged)
