|
rafjr64's photostream |
|
Underdash bulkhead hard lines
This is my bulk head connection and custom hard lines viewed from inside the cab under the dash. ...
All rights reserved
Uploaded on Jan 22, 2009
Bulkhead Engine 1
View of bulkhead from engine side. Bulkhead fitting is a square from Hot Rod Air (made by SunSpec...
All rights reserved
Uploaded on Jan 22, 2009
baffled grommets 1
One of the left is new, never used. One on the right was connected to my pcv with only 150-200...
All rights reserved
Uploaded on Nov 2, 2008
baffled grommets 2
One of the left is new, never used. One on the right was connected to my pcv with only 150-200 miles on it.
All rights reserved
Uploaded on Nov 2, 2008
Bed Wood
Marine Varnish 3-4 coats on each side with a brush. This picture was taken today. I applied it ten...
All rights reserved
Uploaded on Nov 1, 2008
Heater Core 1
Heater Core 2
oil pan
Clearance issue on a SBC oil pan that was installed on a block with a 383 rotating assembly. Ya...
All rights reserved
Uploaded on Oct 31, 2008
Lokar E-brake 1
Eye level looks clean. Although no one will ever see it at eye level.
All rights reserved
Uploaded on Aug 3, 2008
Lokar E-brake 2
Just behind the aluminum knob, right above that screw, I notched out a 1.5 inch piece of the inner...
All rights reserved
Uploaded on Aug 3, 2008
Lokar E-brake 3
In this pic, I added an aluminum spacer (Ace Hardware) to mount the bracket. The rear of...
All rights reserved
Uploaded on Aug 3, 2008
