Microtheist's photostream

We got a Kinect at Ace Monster Toys! Using the software I wrote back in November, I took this depth...

All rights reserved

Uploaded on Jun 9, 2011

0 comments

We got a Kinect at Ace Monster Toys! Using the software I wrote back in November, I took this depth...

All rights reserved

Uploaded on Jun 9, 2011

0 comments

Has your robot outgrown its little brain? Are you running up against the limitations of Arduino? ...

All rights reserved

Uploaded on May 28, 2011

0 comments

This weekend I finished some upgrades to the MakerBot, and tested them out with my most complex...

All rights reserved

Uploaded on Jan 18, 2011

0 comments

Still Life With Programmer. Taken using the depth sensor on a Kinect. I linearized the...

All rights reserved

Uploaded on Nov 26, 2010

0 comments

I printed this working planetary gear set as four separate pieces on the MakerBot. They...

All rights reserved

Uploaded on Jan 18, 2010

0 comments

I printed this working planetary gear set as four separate pieces on the MakerBot. They...

All rights reserved

Uploaded on Jan 18, 2010

0 comments

The first small step toward my printable goggle design: a replacement lens retainer for my current...

All rights reserved

Uploaded on Jan 9, 2010

0 comments

The pawn on the left was printed over the serial cable, which has problems with its transmission rate; the one on the right, from SD.

All rights reserved

Uploaded on Jan 9, 2010

0 comments

The periodic wobble in the edges of this print is a sign that the MakerBot's Z-Stage rods are...

All rights reserved

Uploaded on Jan 4, 2010

0 comments

Home fabrication isn't just for useful parts and toys. :-) Printed as a single piece by Eris, my...

All rights reserved

Uploaded on Jan 2, 2010

3 comments

My extrusion nozzle doesn't match the ones I see online. Here's a high-contrast profile view. Note...

All rights reserved

Uploaded on Dec 21, 2009

0 comments

All rights reserved

Uploaded on Nov 1, 2009

0 comments

All rights reserved

Uploaded on Nov 1, 2009

0 comments

All rights reserved

Uploaded on Nov 1, 2009

0 comments

After sanding, Minimug holds water, even when given the opportunity to destroy...

All rights reserved

Uploaded on Jul 15, 2009  |  Map

4 comments

Successful print of Zack Hoeken's Minimug model from Thingiverse! For the record, here's what I...

All rights reserved

Uploaded on Jul 15, 2009

2 comments

The cells are finally sealed, but the acrylic build base -- which had been flexing from the heat of...

All rights reserved

Uploaded on Jul 14, 2009

0 comments