|
10ftnuthatch's photostream |
|
10ftNuthatch022
Checking for a flat joint while setting up the location of the short sheet prior to adding the GelMagic
All rights reserved
Uploaded on Aug 8, 2007
10ftNuthatch021
Sanding the cured epoxy used to fill the end grain on one set of plywood sheets.
All rights reserved
Uploaded on Aug 8, 2007
10ftNuthatch014
Coating the surface of the scarfs with epoxy to seal off the end grain to keep the plywood from...
All rights reserved
Uploaded on Aug 8, 2007
10ftNuthatch012
Adding shipping tape to the edges to protect the plywood from excess epoxy. Actually saving me from hours of scraping.
All rights reserved
Uploaded on Aug 8, 2007
10ftNuthatch011
10ftNuthatch010
10ftNuthatch009
Checking the scarfs for high and low spots. You can tell where they are by the curve of the plywood...
All rights reserved
Uploaded on Aug 8, 2007
10ftNuthatch008
Closeup showing the "green" lines that mark the lower edges of the plywood sheets.
All rights reserved
Uploaded on Aug 8, 2007
10ftNuthatch007
Re-drawing the "upper" line where the scarf "daylights" from the "top" sheet.
All rights reserved
Uploaded on Aug 8, 2007
10ftNuthatch006
Checking the "ramp" before I set the blade. I later moved the "upper guide"...
All rights reserved
Uploaded on Aug 8, 2007
10ftNuthatch005
Setting the remaining three sheets to their 3" set backs. I will only work one sheet at a time on the next hull.
All rights reserved
Uploaded on Aug 8, 2007
10ftNuthatch004
Marking a line at 3 1/2" for any screws needed to hold the plywood flat to the workbench.
All rights reserved
Uploaded on Aug 8, 2007
10ftNuthatch003
10ftNuthatch002
Setting up and squaring up the table to line up the plywood sheets on.
All rights reserved
Uploaded on Aug 8, 2007
10ftNuthatch001
10ftNuthatch000
Determining the length of plywood needed to add to an 8ft sheet to make 10ft with a 3" overlapping scarf.
All rights reserved
Uploaded on Aug 8, 2007
